Which DNO covers Lincolnshire?

National Grid Electricity Distribution (East Midlands) is the Distribution Network Operator for the whole of Lincolnshire, including Lincoln, Grimsby, Scunthorpe, Grantham, Boston, Skegness, Spalding, and all rural areas. For new supply connections, capacity upgrades, or to report a power cut, contact National Grid ED on 0800 678 3105. The company was formerly known as Western Power Distribution (WPD) before National Grid acquired it in 2021.

What electrical qualifications are needed to work at Scunthorpe steelworks?

Working at British Steel Scunthorpe (the UK's last integrated steelworks) requires a combination of qualifications: HV Authorised Person or Competent Person status for high-voltage work; ATEX/Ex Zone qualification for work in potentially explosive atmospheres (dust and gas hazards in steelmaking areas); CCNSG (National Highways Sector Scheme) Safety Passport for site induction; and BS 7671 qualification (City & Guilds 2391 or equivalent) for LV electrical work. Many contracts also require IPAF (Powered Access) and PASMA (Mobile Access Towers) qualifications for work at height. Contractor competency approval via the site's permit-to-work system is mandatory.

What are the Part P requirements for rural Lincolnshire properties?

Part P of the Building Regulations applies to all domestic electrical installations in England, including rural Lincolnshire. New circuits, consumer unit replacements, and electrical work in kitchens, bathrooms, and outdoors must be either notified to building control or self-certified by a registered competent person (NICEIC, ELECSA, or NAPIT registered electrician). For rural agricultural buildings, Part P does not apply (agricultural buildings are covered by other legislation), but BS 7671 Section 705 requirements still apply. All domestic work must be accompanied by the correct electrical certificate.

What electrical work is needed on agricultural buildings in Lincolnshire?

Lincolnshire has extensive arable farming, bulb growing (in the Spalding area), and food processing. Agricultural electrical requirements include: three-phase supplies for grain dryers, irrigation pumps, and cold stores; supplementary equipotential bonding in livestock buildings under BS 7671 Section 705; IP44 minimum for accessories in agricultural buildings (IP55 recommended for wet areas); SWA armoured cable or PVC in conduit for all fixed wiring; and periodic EICR inspection every 3 years for commercial agricultural premises. Horticultural glasshouses have additional requirements for high-humidity environments under Section 705.

Do RAF bases in Lincolnshire use civilian electrical contractors?

Yes, RAF Coningsby and RAF Waddington do use civilian electrical contractors for non-operational areas such as offices, accommodation blocks, welfare facilities, and non-secure perimeter infrastructure. Contractors must typically hold a security clearance (Baseline Personnel Security Standard — BPSS — as a minimum, with SC clearance for some areas), be approved under the MoD's contractor framework, and comply with Defence Standard 59-411 and other MoD electrical specifications. Some larger contracts are managed through the Defence Infrastructure Organisation (DIO). Domestic-scale electrical contractors are unlikely to access the active airfield or operational areas.

What are the electrical requirements for holiday parks at Skegness and along the Lincolnshire coast?

Holiday parks on the Lincolnshire coast must comply with BS 7671:2018 Section 708 for caravan and camping park installations. Each touring pitch must have: an individually RCD-protected (30mA) supply; an IP55 rated CEE form (BS EN 60309) socket rated at 16A or 32A; and a maximum 25m cable from the pitch socket to the caravan or motorhome. Static caravan connections (permanent) may use standard 13A sockets in weatherproof enclosures. The park's overall installation must have an EICR every 3 years. Annual testing of RCDs and inspection of sockets is also recommended given the harsh coastal environment.

What certifications are needed for a Lincolnshire rental property?

Private landlords in Lincolnshire must comply with the Electrical Safety Standards in the Private Rented Sector (England) Regulations 2020. A valid EICR must be obtained every 5 years (or at each change of tenancy). The EICR must be issued by a qualified person. Any C1 or C2 defects must be remedied within 28 days. A copy of the EICR must be provided to the tenant before they move in. Lincolnshire local authorities — including City of Lincoln Council, North Lincolnshire Council, and South Kesteven District Council — enforce these requirements and can impose financial penalties of up to £30,000 for non-compliance.

LOCATION GUIDE

Electrician Lincolnshire — Find Registered Electricians

Registered electricians across Lincolnshire covering Lincoln, Grimsby, Scunthorpe, Grantham, Boston, Skegness, Spalding, and rural agricultural properties. All work certified to BS 7671.

Start 7-day free trial

Free for 7 days · No charge until day 8 · Cancel anytime · Used by 1,000+ UK electricians

8 min readUpdated 2026-05-18Andrew Moore, Founder of Elec-Mate

Written and reviewed by Andrew Moore, founder of Elec-Mate, against BS 7671:2018+A4:2026, IET Guidance Note 3 and the IET On-Site Guide.

ShareX in W

1,000+

UK electricians

“Replaced three separate apps with Elec-Mate. Certs, quotes, and scheduling all in one place.”

Daniel Palmer — DP Electrical

Key Takeaways

1Lincolnshire is served by National Grid Electricity Distribution (East Midlands) as the DNO — covering Lincoln, Grimsby, Scunthorpe, Grantham, Boston, Skegness, and Spalding.
2Scunthorpe's steel works (British Steel) is one of the UK's largest industrial electrical consumers, requiring specialist HV competency, ATEX qualifications, and industrial maintenance skills.
3Lincolnshire has one of the largest areas of agricultural land in England. Agricultural wiring under BS 7671 Section 705 covers specialist requirements for grain drying, cold stores, and irrigation.
4RAF Coningsby and RAF Waddington are significant employers of Ministry of Defence (MoD) approved electrical contractors, with specific security clearance and MoD specification requirements.
5Lincolnshire's Lincolnshire coast — Skegness, Mablethorpe, Cleethorpes — has hundreds of holiday parks requiring BS 7671 Section 708 caravan park electrical compliance and regular EICR inspections.
6All domestic electrical work creating new circuits must comply with Part P Building Regulations. Registered competent persons (NICEIC, ELECSA, NAPIT) can self-certify without separate building control notification.

01 · Location Guide

Areas Covered — Lincolnshire Electricians

Lincolnshire is one of England's largest counties by area. Electricians on Elec-Mate cover all major towns and rural areas including:

Lincoln — county city, cathedral quarter, and surrounding villages including Sleaford, Gainsborough, and Market Rasen
Grimsby & Cleethorpes — port town, fish processing industry, and the Humber Estuary energy corridor
Scunthorpe — steelworks town in North Lincolnshire, with extensive industrial electrical demand
Grantham & Stamford — south Lincolnshire towns on the A1 corridor with significant new housing development
Boston, Skegness, Spalding — agricultural heartland, coastal holiday parks, and Lincolnshire's bulb-growing area

For consumer unit replacements or landlord EICRs across Lincolnshire, Elec-Mate connects you with qualified local electricians.

Free download

Get the BS 7671 A4:2026 Cheat Sheet — free

Every key change in the 2026 amendment on one page. AFDDs, TN-C-S protection, new schedule columns, model forms. Pinned on your van dash.

Every regulation change summarised
New model forms (EIC + MEIWC)
Free PDF — no subscription

02 · Location Guide

DNO Networks in Lincolnshire

National Grid Electricity Distribution (East Midlands) is the Distribution Network Operator for Lincolnshire. Supply connections and network faults are managed through National Grid ED.

National Grid Electricity Distribution (East Midlands)— covers all of Lincolnshire. Power cuts emergency line: 0800 678 3105. New connections: nationalgrid.co.uk/electricity-connections.
Coastal exposure — the Lincolnshire coast suffers from salt-spray corrosion which accelerates degradation of outdoor electrical equipment. IP56 minimum for all external electrical enclosures in coastal locations is recommended.

03 · Location Guide

Steel Industry Electrical Work at Scunthorpe

British Steel's Scunthorpe works is one of Europe's largest integrated steelmaking facilities. The site operates blast furnaces, coke ovens, a hot strip mill, and plate mill — all of which require extensive high-voltage and low-voltage electrical infrastructure.

HV substation maintenance — 132kV, 33kV, and 11kV switchgear servicing, protection relay testing and calibration, and power transformer maintenance require IET or relevant HV qualified Authorised Person status.
Motor drives and control gear — rolling mill drives, fan motors, and pump sets require LV panel maintenance, drive fault finding, and motor control centre (MCC) servicing.
ATEX hazardous areas — coke oven gas, blast furnace gas, and dust zones require ATEX/Ex certified equipment and qualified installation in accordance with BS EN 60079.

Industrial Project Certificates with Elec-Mate

Generate Electrical Installation Certificates and test schedules for industrial and commercial projects. Manage certificates across your whole team.

Try Elec-Mate free

04 · Location Guide

Agricultural & Horticultural Electrical Work

Lincolnshire is England's most productive arable county, with grain, vegetables, and flowers grown at scale across the county. The agricultural and food processing sector creates significant specialist electrical demand.

Section 705 — agricultural premises — mandates IP44 minimum for accessories in agricultural areas, equipotential bonding in livestock zones, and SWA or conduit-protected cables throughout.
Grain drying and cold stores — three-phase 400V supplies for dryer motors (typically 11kW to 45kW), star-delta starters or VFDs, and cold store compressor sets.
Glasshouse and polytunnel electrical — high-humidity environments require IP65 rated wiring systems and accessories. Horticultural lighting installations must comply with BS 7671 Chapter 52 and the specific zone requirements of Section 705.

Try Elec-Mate free for 7 days

16 certificate types, 70+ calculators, RAMS, quoting, invoicing, AI agents, and 46+ training courses — from £6.99/mo.

Start free trial

05 · Location Guide

RAF Base Electrical Work — Coningsby & Waddington

RAF Coningsby (home of the Typhoon force and the Battle of Britain Memorial Flight) and RAF Waddington (home of ISR aircraft) are two of Lincolnshire's most significant employers. Civilian electrical contractors work on non-operational infrastructure at both bases.

Security clearance — all civilian contractors at RAF stations require a minimum BPSS (Baseline Personnel Security Standard) check, with SC (Security Check) clearance required for some areas. Allow 4 to 8 weeks for clearance processing before work can commence.
MoD specifications — electrical installations at MoD sites must comply with Defence Standard 59-411 (Electromagnetic Compatibility) and Defence Infrastructure Organisation technical guidance, in addition to BS 7671.

06 · Location Guide

Coastal Holiday Park Electrical Compliance

The Lincolnshire coast hosts hundreds of holiday parks from Cleethorpes to Chapel St Leonards. These require specialist electrical services including BS 7671 Section 708 pitch supply installations, caravan electrical connections, and regular EICR inspection.

BS 7671 Section 708 — each touring pitch must have an individually protected 16A or 32A IP55 socket (CEE blue form). All pitch supplies must be 30mA RCD protected. Maximum 25m cable run to each pitch.
Coastal corrosion — stainless steel or hot-dip galvanised fittings are recommended for external electrical enclosures on the Lincolnshire coast, where salt-laden air significantly accelerates corrosion of standard galvanised steel.
EICR frequency — holiday parks should have an EICR every 3 years. The site licence conditions from the local authority may require more frequent inspection for older installations.

For EICR observation codes and what they mean for your holiday park, see our detailed guide.

Lincolnshire Electrician — Frequently Asked Questions

What electricians say

Verified reviews from the UK App Store.

One App for Everything!

Elec-Mate is my go to app for business and electrical work. It's feature rich without feeling cluttered. A true all in one app for quotes, certs, calculations, RAMS, EICRs, and more. I use it every day without fail, and it makes my workflow much smoother since I'm not jumping between apps anymore. The price-to-feature ratio is excellent. Any issues I've had, the developer responds within the hour and usually fixes them the same day. 100% recommend.

Fantastic app for electricians

I've used the app and the web based version for a while now and it's well worth the investment. If you're an apprentice or experienced Spark give it a go, you won't be disappointed.

Absolutely amazing

I've been using Elec-Mate for a while now, and honestly, it's one of the best apps I've ever downloaded. Every aspect of it feels thoughtfully designed, from the clean and intuitive interface to the powerful features that make everything so easy to manage. It's clear that a lot of care and attention went into building this app, and it shows in every detail.

Trusted by electricians across the UK

Real feedback from real sparks

“Replaced three separate apps with Elec-Mate. Certs, quotes, and scheduling all in one place.”

Daniel Palmer

Sole Trader · DP Electrical

“I've won two contracts this month because I could turn quotes around same-day with the AI cost engineer.”

Nathan Perry

Electrician · NP Electrical Services

“The study centre got me through my AM2. Mock exams and flashcards are brilliant.”

Jake Pizey

3rd Year Apprentice · Apprentice

7-Day Free Trial — Cancel Anytime, No Hassle

Find a Lincolnshire Electrician Today

Browse NICEIC and ELECSA-registered electricians across Lincolnshire. All work covered by Part P certification and public liability insurance.

“Replaced three separate apps with Elec-Mate. Certs, quotes, and scheduling all in one place.”

Daniel Palmer, DP Electrical

From £6.99/mo after trial — less than a coffee a week

or download the app

7 days free, then from £6.99/moCancel in one tap — no calls, no hassleiOS, Android & WebBS 7671 compliant

Electrician Lincolnshire — Find Registered Electricians

Key Takeaways

Areas Covered — Lincolnshire Electricians

Get the BS 7671 A4:2026 Cheat Sheet — free

DNO Networks in Lincolnshire

Steel Industry Electrical Work at Scunthorpe

Industrial Project Certificates with Elec-Mate

Agricultural & Horticultural Electrical Work

Try Elec-Mate free for 7 days

RAF Base Electrical Work — Coningsby & Waddington

Coastal Holiday Park Electrical Compliance

Lincolnshire Electrician — Frequently Asked Questions

Which DNO covers Lincolnshire?

What electrical qualifications are needed to work at Scunthorpe steelworks?

What are the Part P requirements for rural Lincolnshire properties?

What electrical work is needed on agricultural buildings in Lincolnshire?

Do RAF bases in Lincolnshire use civilian electrical contractors?

What are the electrical requirements for holiday parks at Skegness and along the Lincolnshire coast?

What certifications are needed for a Lincolnshire rental property?

Continue reading

Electrician Norfolk

Electrician Cambridgeshire

EICR for Landlords

EICR Observation Codes Explained

EICR Certificate App

What electricians say

One App for Everything!

Fantastic app for electricians

Absolutely amazing

Trusted by electricians across the UK

Find a Lincolnshire Electrician Today